High Quality Speed Controller
|Min. Order (Pieces)||FOB Price|
|10+||US $10-90 / Piece|
Single Phase Electronic Speed controller
1. Check that the speed controller supplied is compatible with the fan
2. Intall in a dry sheltered position.Do not install in close proximity to a heat source.
3. Remove the front cover of the controller by unscrewing the fascia fixing screws.This provides access to mounting holes and electrical terminals.
All wiring must be carried out by a suitably qualified and competent person and comply with the current applicable regulations.
Switch on the controller by operating the ON/OFF switch.Rotating the control knob clockwise will increase the speed of the fan from the pre-set minimum to full speed.
Minimum speed adjustment
On certain fans the factory set minimum pre-set may need adjusting.This can be achieved by roating the minimum trimmer inside the speed controller clockwise to increase the minimum level.
Maximum speed adjustment
This can be achieved by rotating the maximum trimmer inside the speed controller anti-clockwise to decrease the maximum level.
Installation of the controller and adjustment of the internal minimum trimmers should be carried out with the electrical supply isolated.
|Model no.||Eelctrical Supply||Rating||Diemensions (H X W X D)||Mounting|
|MSC1.5||230V 1Ph 50Hz||1.5A||89mm x 89mm x 42mm||Surface/Flush|
|EMSC1.5||230V 1Ph 50Hz||1.5A||87mm x 147mm x 46mm||Surface/Flush|
|EMSC3||230V 1Ph 50Hz||3A||87mm x 147mm x 46mm||Surface/Flush|
|EMSC5||230V 1Ph 50Hz||5A||87mm x 147mm x 46mm||Surface/Flush|
|EMSC6||230V 1Ph 50Hz||6A||147mm x 87mm x 50mm||Surface|
|EMSC10||230V 1Ph 50Hz||10A||192mm x 110mm x 60mm||Surface|